using the parent axis to locate attributes of a comment apos s parent element
báo cáo khoa học: " Stable relocation of the radial head without annular ligament reconstruction using the Ilizarov technique to treat neglected Monteggia fracture: two case reports" doc
Ngày tải lên :
11/08/2014, 02:21
... under analgesia We found the Ilizarov technique to be advantageous in other respects as well, as it allows lengthening and angulation in several planes, and the processes of lengthening and angulation ... obtained Radiographs in both anterio-posterior and lateral view were studied to assess the dislocation of the radial head Because the dislocation in both of our patients was an anterolateral one ... cases, an anterolateral dislocation of the radial head was confirmed by radiography An underlying ulnar injury in both our cases was suspected because of the loss of proximal convexity of ulna (Figure...
- 6
- 327
- 0
báo cáo khoa học: " Improving eye care for veterans with diabetes: An example of using the QUERI steps to move from evidence to implementation: QUERI Series" ppsx
Ngày tải lên :
11/08/2014, 16:21
... during an eyecare visit with a diabetes patient at study site A The provider assigned risk status for these visits as shown in Table A subset of patients was subsequently selected for testing the ... manual version of the PRSS was developed using a Microsoft® Access database Initial development of the PRSS took place at one study site (Site A) with the intent of developing similar but organizationally ... greatest risk for preventable visual loss In addition, the PRSS database was used to identify patients with no eye appointment in the past two years This step was not part of the original study plan...
- 11
- 443
- 0
Báo cáo y học: "Using Topology of the Metabolic Network to Predict Viability of Mutant Strains" docx
Ngày tải lên :
14/08/2014, 16:20
... value that gives an optimal performance, as measured either by accuracy or significance of the χ statistic (DataTable3.xls) Quantitative analysis of performance To assess the performance of synthetic ... to FBA and EMA on the smaller dataset is worse, but this smaller dataset only has data for mutants affecting the central metabolism and therefore may be biased, while the large dataset of insertional ... metabolic and transport reactions On the insertional dataset, the accuracy of synthetic accessibility approach is comparable to FBA and MOMA The performance of synthetic accessibility as compared...
- 30
- 167
- 0
Tài liệu Using the Get* Methods to Read Column Values doc
Ngày tải lên :
24/12/2013, 01:17
... SQL Server types and the values supported by those types in Table 2.3 of Chapter 2, "Introduction to Databases." Note The Get* methods are defined in all of the DataReader classes and work for all ... unsigned integer between and 216 - (65,535) Note The standard C# types are defined in the System namespace Table 9.4 shows the SQL Server types, the compatible standard C# types, and the DataReader ... smallint short GetInt16() smallmoney decimal GetDecimal() Table 9.4: SQL SERVER TYPES, COMPATIBLE STANDARD C# TYPES, AND GET* METHODS SQL SERVER TYPE COMPATIBLE STANDARD C# TYPE GET* METHOD sql_varient...
- 3
- 349
- 0
Tài liệu Using the Shape Language to Retrieve Hierarchical Data doc
Ngày tải lên :
24/12/2013, 05:15
... constructed Shaping is an alternative to JOIN and GROUP BY syntax that you can use to access parent/ child data and associated summary data The connection string using data shaping is shown here: ... data provider The chapter is returned as a field in the data reader with a data type of Object that is a DataReader Hierarchical result sets combine the results for multiple queries into a single ... Provider=MSDataShape;Data Provider=SQLOLEDB;Data Source=(local); Initial Catalog=Northwind;Integrated Security=SSPI; For more information about data shaping or the MSDataShape provider, see the MSDN...
- 3
- 343
- 0
Tài liệu Using the Key Class to Add Interactivity docx
Ngày tải lên :
21/01/2014, 13:20
... reacts to the Up and Down Arrow keys rather than the Right and Left Arrow keys The first part of this statement says that if the Up Arrow key is pressed, the movie clip instance is moved to its ... exercise, you'll place actions on the first frame of the Actions layer With the Actions panel open, select Frame in the Actions layer and add this script: var speed:Number = 3; At the end of this ... instance to the right) However, if the Right Arrow key is not pressed, that part of the script is ignored and the next part is evaluated—if the Left Arrow key is pressed, the movie clip instance...
- 5
- 347
- 0
Báo cáo y học: "Effects on management and outcome of severe sepsis and septic shock patients admitted to the intensive care unit after implementation of a sepsis program: a pilot study" docx
Ngày tải lên :
13/08/2014, 19:20
... 0.05 was considered significant The statistical software package SPSS 15.0 (SPSS Inc., Chicago, IL, USA) was used for statistical analysis Results From January 2005 to June 2007, 87 patients met ... assessment of sepsis team activity before ICU admission appears mandatory for a better understanding of this relevant issue We are grateful to the physicians and nurses of ICU and all hospital ... and after June 2006, in order to assess the impact of 'sepsis team' on patient outcome Students' t-test, chi-squared, Fisher 's exact test, and analysis of variance single-factor analysis were used...
- 8
- 280
- 0
The marketing plan to launch one of the ABBOTT maternal nutrition products New Similac Mum Advance EyeQ plu
Ngày tải lên :
24/11/2014, 02:36
... platforms in terms of different channels and messages, each of these platforms is an important part of creating awareness of the business and the products among various stakeholders (inspiration ... Plan These days, no business can afford to trade without a marketing plan This applies to all types of businesses, large or small, online or bricks and mortar A marketing strategy enables us to ... customers Examples of public relations are the annual reports from a company, participation in seminars and sponsorships and publications Personal selling is when a sales person from the company...
- 40
- 523
- 2
Using the phrase used to
Ngày tải lên :
17/07/2015, 20:44
... She used to spend a lot of money on cosmetics, but now she doesn’t I used to visit my grandparents often Be first to know when grammar rules change! Sign up to our newsletter here: englishgrammar.org ... often Be first to know when grammar rules change! Sign up to our newsletter here: englishgrammar.org (It 's free) Powered by TCPDF (www.tcpdf.org) ...
- 2
- 190
- 0
AN1000 using the MSSP module to interface SPI™ serial EEPROMs with PIC18 devices
Ngày tải lên :
11/01/2016, 16:35
... to be properly initialized Code examples are shown for each SSP STATUS Register (SSPSTAT) SSPSTAT holds all of the Status bits associated with the MSSP module In SPI mode 1,1 the SMP bit of the ... is sent The STATUS register is shifted out on the Serial Out pin A value of 0x02 shows that the WEL bit in the STATUS register has been set The device is now ready to a write to either the STATUS ... which serves as additional protection against unwanted writes The part remains in a continuous RDSR loop and the WIP status is evaluated until the bit is cleared Figure shows the Status Register...
- 12
- 344
- 0
AN1004 using the c18 compiler to interface microwire serial EEPROMs to PIC18 devices
Ngày tải lên :
11/01/2016, 16:35
... DS0100 4A- page AN1004 READ COMMAND (START BIT, OPCODE, ADDRESS AND DATA) Figure shows an example of the Read command The device is selected and the Start bit, opcode and the word address are sent ... AN1004 FIRMWARE DESCRIPTION The purpose of the program is to show individual features of the Microwire protocol and give code samples of the Start bit, opcodes and addressing schemes, so that ... finishes A ms delay needs to be added if the Ready/Busy status is not being polled This code uses Ready/Busy polling Figure shows an example of the Write command The device is selected and the Start...
- 10
- 240
- 0
AN1018 using the c18 compiler to interface SPI serial EEPROMs with PIC18 devices
Ngày tải lên :
11/01/2016, 16:36
... AN1018 FIRMWARE DESCRIPTION The purpose of the program is to show individual features of the SPI protocol and give code samples of the instructions and addressing schemes so that the basic ... STATUS register is shifted out on the Serial Out pin A value of 0x02 shows that the WEL bit in the STATUS register has been set The device is now ready to a write to either the STATUS register ... DS0101 8A- page AN1018 READ COMMAND (OPCODE, ADDRESS AND DATA) Figure shows an example of the Read command For this, the device is selected As with the Write command, the Most Significant bit of the address...
- 12
- 236
- 0
AN1096 using the c30 compiler to interface SPI serial EEPROMs with dsPIC33F and PIC24F
Ngày tải lên :
11/01/2016, 16:39
... AN1096 FIRMWARE DESCRIPTION The purpose of the program is to show individual features of the SPI protocol and give code samples of the instructions and addressing schemes so that the basic ... Because page writes cannot cross page boundaries, care must be taken to avoid having data wrap around to the beginning of the page and overwrite existing data BYTE WRITE COMMAND, ADDRESS AND DATA ... AN1096 WRITE ENABLE a write is attempted to either the array or the STATUS register The WEL bit can be cleared by issuing a Write Disable command (WRDI) and is also automatically reset if the...
- 12
- 624
- 0
AN1100 using the c30 compiler to interface serial EEPROMs with dsPIC33F
Ngày tải lên :
11/01/2016, 16:44
... devices, there are many benefits of using a software method of I2C communicating One of the obvious advantages is that any two I/O pins can be used In most cases speed is not an issue so a software ... C K A C K DS0110 0A- page AN1100 Data Byte and Stop Bit Transmission Once the word address has been transmitted and the last ACK bit has been received, the data byte can be sent Once again, the ... Bytes Successively Figure 10 shows the last two bytes of a 16-byte sequential read operation Note that the master pulls SDA low to transmit an ACK bit after the first data byte, but leaves SDA...
- 16
- 328
- 0
AN1137 using the MCP1631 family to develop low cost battery chargers
Ngày tải lên :
11/01/2016, 16:45
... × dt The rate of change of voltage across the capacitor is related to the amount of current through the capacitor and the size or energy storage capability of the capacitor For the SEPIC converter ... VOUT, the anode of the schottky diode is connected to the SEPIC coupling capacitor The voltage across the coupling capacitor voltage is equal to VIN; the voltage across the diode is equal to VOUT ... when charging a +3.0V Li-Ion battery at 2A Any power dissipation over a few watts is a challenge to cool Cooling 18 watts of power dissipation is no easy task, airflow and large heatsinks are required...
- 20
- 420
- 0
Tài liệu Module 1: Introduction to Advanced Administration of a Windows 2000 Network docx
Ngày tải lên :
17/01/2014, 08:20
... request fails ACEs that deny access are listed first in the DACL The security subsystem processes the ACEs in order and grants access to the object as soon as an ACE that allows the requested access ... Policy allow administrators to centrally manage a large number of users, computers, and network resources Senior administrators can delegate administrative tasks to other administrators Administrators ... whenever a user attempts to gain access to an object When the user runs an application, a new process is launched that inherits the user s access token The access token is permanently attached to each...
- 26
- 444
- 0
Tài liệu Using XSD Schema Files to Load and Save a DataSet Structure pptx
Ngày tải lên :
26/01/2014, 10:20
... see the MSDN Library The WriteXmlSchema( ) and ReadXmlSchema( ) methods of the DataSet class are used to write and read the XSD schema for the XML data The schema is written using the XSD standard ... writeSchemaButton_Click(object sender, System.EventArgs e) { DataSet ds = new DataSet( ); SqlDataAdapter da; // Fill the Order table and add it to the DataSet da = new SqlDataAdapter("SELECT * FROM Orders", ConfigurationSettings.AppSettings["Sql_ConnectString"]); ... ...
- 8
- 403
- 0