... cậptừxa và cácgiaothức sử dụng trong
truy cậptừxa
1.Kết nối truycậptừxa
Tiến trình truycậptừxa được mô tả như sau: người dùng từxa khởi tạo
một kết nối tới máy chủ truy cập. ... mỗi phiên truycậptừ xa.
Theo dõi các kết nối truycậptừ xa: khả năng theo dõi các kết nối truy
cập từxa của một Máy chủ truycập cho ta xử lý các vấn đề phức tạp về sự cố
mạng. Các thông ... thông qua kết nối truycậptừxa này
(hình 5.1)
Hình 5.1
2. Giaothứctruycậptừxa
SLIP (Serial Line Interface Protocol), PPP và Microsoft RAS là cácgiao
thức truycập để tạo lập...
... riêng để cấp phát cho các máy truycậptừ xa.
Phương thức sử dụng DHCP server, máy chủ truycập nhận địa chỉ
IP từ
DHCP server và gán cho các máy truycậptừ xa. Phương thức này rất linh hoạt, ... thông qua kết nối truycậptừxa này
(hình 5.1)
Hình 5.1
2. Giaothứctruycậptừxa
SLIP (Serial Line Interface Protocol), PPP và Microsoft RAS là cácgiao
thức truycập để tạo lập ... cho các máy
truy cậptừ xa.
Máy chủ truycập có thể gán động một địa chỉ IP cho các máy truycập
từ xa. Địa chỉ IP này thuộc trong khoảng địa chỉ mà ta đã cấu hình trên máy
chủ truy cập. ...
... mỗi phiên truycậptừ xa.
Theo dõi các kết nối truycậptừ xa: khả năng theo dõi các kết nối truy
cập từxa của một Máy chủ truycập cho ta xử lý các vấn đề phức tạp về sự cố
mạng. Các thông ... số vấn đề xử lý sự cố trong truycậptừ xa.
Các vấn đề liên quan đến sự cố trong truycậptừ xa, thường bao gồm:
Giám sát truycậptừ xa: giám sát máy chủ truycập là phương pháp tốt
nhất ... thông qua kết nối truycậptừxa này
(hình 5.1)
Hình 5.1
2. Giaothứctruycậptừxa
SLIP (Serial Line Interface Protocol), PPP và Microsoft RAS là cácgiao
thức truycập để tạo lập...
... of service of users holding
a reservation, the latter by erasing some of their packets. As an example, Q
pe
[K]fora
(511, 229, 38) BCH code and a spreading factor X = 7 is shown in Figure 1.7. ... BCH
code is used for forward error correction coding. For more explanations and details on
the exact conditions considered, refer to Chapter 5. In such a scenario, clearly, the notion
of a slot ... channel transmission rate, e.g. one packet per TDMA frame fitting into one
time-slot). A typical example would be a voice source subject to voice activity detection.
By reserving resources on the...
... the first 4G system launch to 2006.
At the time of writing, there is no agreed view yet on what exactly will constitute a 4G
system, what features it will offer that distinguishes it significantly ... fundamental
impact on the telecommunications industry, including cellular communications. We will
examine how this affects 3G, what new requirements arise and how these can be met
through subsequent ... UK in the year 2000
In the following, we will consider 2 × 10 MHz plus 5 MHz of spectrum as an example
allocation for an individual operator, as quite a few operators will have to deal with
such...
... yêu cầu file cấu hình. Các IOS image file cũng có
thể đuợc lưu trong TFTP_server.
I.2. Truycập dùng vệ tinh:
I.2.1. Cơ bản về truy n dữ liệu bằng vệ tinh:
Cách thứctruy n dữ liệu dùng ... khoảng cách địa lý.
Để dùng cách thứctruy n bằng vệ tinh, ta cần phải trang bị dĩa và các adapters. Chi
phí cho một dĩa khoảng $500, công cài đặt khoảng 200. Các vệ tinh cho phép truy n
dữ ... LAN hơn là một công
nghệ được dùng để truycập Internet. IEEE 802.11 quy định các tiêu chuẩn về tín
hiệu và giaothức nhằm đảm bảo tính tương thích cho các thiết bị mạng không dây.
802.11 có...
... proba-
bility p with which they access a slot with every further retransmission attempt (see for
example Reference [126]). This is termed transmission backoff, and exponential transmis-
sion backoff ... discussed in Section 4.11, including a global
probabilistic control scheme. The latter will also be examined in more detail in Chapter 6.
3.5.2 Increasing the Throughput with Splitting or Collision
Resolution ... advantageous in terms of battery life. In Section 4.11, the
required amount of signalling resources is examined in more detail, and it is found that
it is quite moderate.
3.7.4.4 On the Content of Contention...
... to the considered RACH (i.e. one time-slot per TDMA
frame in the ‘non-combined case’). In this example, TX
INTEGER < 8.
If the base station receives a channel request message correctly, and ... Time-slot Numbers
(TN) from 0 to 7, are grouped into a TDMA frame. The duration of such a frame
is exactly 120/26 ms, which is approximately 4.615 ms. As a consequence, a time-
slot lasts 15/26 ms, ... configuration,a
special case of the generic multi-slot allocation. The basic physical channels are exactly
the same as those in GSM with one exception: an HSCSD configuration can include unidi-
rectional...
... approximate bit error rate
P
e
could be calculated using the error function. Pursley proposed to do exactly this in
1977. Furthermore, expanding on a paper from 1976 [244], he provided expressions ... PHYSICAL LAYER AND FOR USER TRAFFIC GENERATION
A possible reason for these discrepancies could be the exact spatial distribution of the
interference considered. Although in all references, uniform distribution ... as a function of traffic normalised to the activity factor
does not depend significantly on the exact choice of these values. Exceptions are high
load conditions, where the reduced number of spurts...
... header
overhead is explicitly accounted for. In Equation (6.1) on the other hand, it is not, since the
exact overhead specifically due to packet-switching may depend on the chosen implemen-
tation and ... into one slot (but for the standard data-
rate, it sends again only one burst per TDMA frame, exactly as in the basic scheme). The
group size is determined by the interleaving depth d
il
. For ... frequency-division duplexing,
the above description refers to the uplink channel only, while the exact structure of the
downlink channel does not matter for MD PRMA operation, except for possible...
... is not
acceptable. Therefore, all time-slots must be loaded with at most (or for the benchmark
exactly) K
max
users. The same is true in a dynamic scenario with call arrivals and call
departures, ... probabilistic
access control. While their results for perfect power control correspond almost exactly
to the results reported in Reference [29], since they used the access function parameters
published ... simultaneously
is not equivalent to the number of channels (or here, resource units) U available. This is
exactly where M
0.01
(or M
0.001
, depending on the quality required) comes into play. Since
this...
... units (whether these be code, time, or code-time-slots).
This is exactly how Figures 8.1 to 8.3 were obtained, and while the exact P
drop
behaviour depends on the scheme and the p
v
value considered, ... particularly at low load. However, while the performance, as far as statistically relevant,
is exactly the same for x = 0 (i.e. immediate acknowledgement), the Bayesian algorithm
suffers much ... bursts per spurt amounts to less than 1%. The small
gain achieved by increasing D
max
is almost exactly compensated by this additional traffic.
Most interestingly, unlike MD PRMA, MD FRMA does not...
... for
S-ALOHA, the average access-delay performance over all classes with these prioritised
algorithms exactly matched the performance of the single-class algorithm, we did not
invest any further effort ... throughput
advantage is also maintained in prioritised versions of such protocols, as shown for
example in Reference [270] (for a selection of other relevant references in this field,
the reader...
... the active set receives the terminal’s signal at sufficient quality (and this is exactly
what is aimed for). Example results showing the benefit of soft handover for two base
stations in the active ... the cell edge towards neighbouring cell A, but far away from neighbouring cell B,
while it is exactly the other way round for the user scheduled next, which will indeed
lead to intercell interference ... between 12 RACH subchannels, hence every 12th access slot
pertains to a specific subchannel (the exact mapping can be found in TS 25.214). The
above-mentioned PRACH partitioning is defined in terms...
... core network, so that different types of radio technologies could be
connected to it (which is exactly what is happening here with UTRA and EGPRS). This
resulted in functionality located in the ... network-controlled ‘plain voice service’ is replicated on the packet-switched
infrastructure, with exactly the same features as the original circuit-switched service, then
the end-to-end principle ... soft-capacity feature can be obtained all the
same. This is because the quality in terms of, for example, dropping probability, P
drop
,
deteriorates only gradually when the target load-level is...