... 7(6): 1513-1523
2. Sambrook, J., D. Russel. 'Molecular Cloning: A Laboratory Manual. ' Cold Spring Harbour
Laboratory Press 3rd Ed
3. http://www.fordras.com/whatis.htm
4. Serghini, ... principle
to develop alkaline lysis plasmid miniprep. According the Molecular Cloning: A Laboratory
Manual by Sambrook and Russell (2), the cells that contained the plasmids are treated with ... insert DNA from agarose gel slice. 25-25
11 Mobilization of recombinant Ti plasmid from common
laboratory host (E. coli) to an Agrobacterium tumefaciens
strain
26-27
12 Agrobacterium tumefaciens-mediated...
... tùy thích
Connect using: COM1
37
BACKUP VÀ RESTORE IOS:
Trong lab này yêu cầu bạn thực hiện trước các câu lệnh trong phần XÓA CẤU HÌNH
ROUTER trang 19, sau đó ... rX_flash //ghi nhận tên file để cung cấp trong quá _ trình backup
[7824912 bytes used, 563696 available, 8388608 total]
8192K bytes of processor board System flash (Read ONLY)
R”X”#copy flash ... current system image to use the ROM based image for the copy.
Routing functionality will not be available during that time.
If you are logged in via telnet, this connection will terminate.
Users...
... vien lop CCNA
#
Router(config)#^Z
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#exit
Router con0 is now available
Press RETURN to get started.
Chao cac hoc vien lop CCNA
Router>
– ...
RouterA#show version
–Kiểm tra lại lần nữa bằng show flash.
Lab 1-9: Nạp IOS từ TFTP Server cho router chạy từ
RAM
Lab 1-9: Nạp IOS Image từ TFTP Server cho router chạy từ RAM
Mô ... thì mật khẩu vẫn ở
dạng mã hóa trừ khi đặt lại mật khẩu.
Lab 1-3: Các lệnh cơ bản của hệ điều hành Cisco IOS
Lab 1-3: Các lệnh cơ bản của hệ điều hành Cisco IOS
1. Đặt router...
... hình line console.
Boston(config-line)# logging Bật tính năng synchronous logging.
CCNA LAB GUIDE
Version 4.0
(Cisco Certified Network Associate)
Tác ... http://www.vnexperts.net
6
Hình 1-5: Cáp V35 DTE và DCE.
Hình 1-6: Đầu chuyển đổi từ USB sang Serial cho Labtop.
5. Phương pháp sử dụng các loại cáp Serial.
- Bảng 1-2 sẽ mô tả cách để sử dụng các ...
(Serial)
type number
1760 On board Fast Ethernet Interface-
type 0/port
Fa0/0
Slot 0 WIC/VIC (Voice
interface card)
Interface-
type 0/port
S0/0 và S0/1
V0/0 và V0/1
Slot 1 WIC /VIC Interface-
type...
...
CCNA LAB GUIDE
Version 4.0
(Cisco Certified Network Associate)
Tác giả: Dương Văn Toán
Hà Nội - 12/10/2008
www .ccna- 4.blogspot.com
www .ccna4 u.tk
...
124
126
129
130
135
135
142
148
158
158
162
171
171
www .ccna- 4.blogspot.com
www .ccna4 u.tk
Created by: Dương Văn Toán – CCNP, CCSP, MCSE, LPI level 1. http://www.vnexperts.net ... http://www.vnexperts.net
6
Hình 1-5: Cáp V35 DTE và DCE.
Hình 1-6: Đầu chuyển đổi từ USB sang Serial cho Labtop.
5. Phương pháp sử dụng các loại cáp Serial.
- Bảng 1-2 sẽ mô tả cách để sử dụng các...
... switches involved in
this lab may interfere with the expected outcome from each section
of this lab. Therefore, it is recommended you begin working
through these labs only after resetting the ... 172.16.1.20 into the switch port
labeled "3x" (VLAN 3).
29. On SwitchB, connect the network cable from the PC with the IP address 172.16.1.21 into the switch port
labeled "3x" (VLAN ... VLAN 3.
6. Disconnect the cable plugged into SwitchA's port labeled "10x." Connect it to SwitchB's Ethernet port labeled
1x.
7. From either PC, attempt to ping the corresponding...
... interfaces.
This is the Lab Scenario for the second edition
of the CertificationZone CCNA WAN Protocols
Issue.
There is an additional Lab Scenario on the
subject. See the 1999-12 CCNALab Scenario
on ... 6
http://www.certificationzone.com/studyguides /?Issue=15&IssueDate=07-01-2000&CP= 11/06/01
Date of Issue: 07-01-2000
CCNA WAN Protocols Lab Scenario
by Dale Holmes
Introduction
Set-up Items
Solution
Configuring the Physical ... the ability to configure Cisco routers for Frame Relay connections.
You decide to set up a home lab and get some practice before your meeting with the network manager.
The first thing you need...