Coot By Perry Bailey Copyright 2000 1. Fold a square in half on the diagonal one direction then fold in half on the diagonal the other way. 2. Fold up a little less than 1/3 from the top. 3. Fold the model in half, and turn 90 degrees. 4. Fold the long edge up to the top on each side. Reverse fold up the neck, part of neck is inside the body, you know the neck is right when it touches at the underlying layers in the front. 5. 6. Another outside reverse fold for the head. 7. Pleat the beak in a little for that waterfowl look! 8. Just taking a break here to say to mention how far the tail sticks out all depends on step 2. 9. Grab the inner flap and reverse fold that puppy all the way to the end of flap, so it comes down even with the bottom of the model. 10. Grab the inner flap again and bring at least part of it back up again. This time it doesn’t have to go the length of the flap. The finished Coot! White side up NOTE: When the model is finished there should be a flap sticking up inside of the model you can fold over to lock the body together. . Coot By Perry Bailey Copyright 2000 1. Fold a square in half on the diagonal. again. This time it doesn’t have to go the length of the flap. The finished Coot! White side up NOTE: When the model is finished there should be a flap