... is on
CCIE. book Page 88 Friday, June 14, 2002 3:57 PM
Router CLI 89
Switch Commands
On the CCIE Routing and Switching (R & S) written exam, you need to know general switch
commands and their ... network (VLAN), and type. Example 3-22
shows that switch ports 2/4 and 2/9 are in VLAN 24.
Configuring a VLAN
VLANs are configured with the set vlan command. Example 3-23 shows th...
... the routing of information and methods to determine paths
to a destination. Information at this layer is called packets. Specifications include routing
protocols, logical network addressing, and ... Routers operate in this layer.
The CCIE lives and dies in this layer.
Examples of network layer specifications are the following:
• Internet Protocol (IP)
• Routing Information Prot...
... site:
www.cisco.com/warp/public/10/wwtraining/certprog/
CCIE Certifications
The three CCIE certifications are as follows:
•
CCIE Routing and Switching (CCIE R&S)
•
CCIE Communications and Services (CCIE C&S)
•
CCIE Security
This ... the CCIE R&S written exam and one for the general knowledge portion
of the CCIE C&S exam.
CCIE R&S...
... IOS-based
commands, and set-based, command-line interface (CLI) commands. The IOS-based
commands (found in Catalyst 1900/2820, 2900XL, and 3500XL) are similar to many IOS
commands used on Cisco ... Street
Indianapolis, IN 46290
Cisco CCNP Switching Exam
Certification Guide
Tim Boyles and Dave Hucaby, CCIE #4594
x
Chapter 3
Basic Switch and Port Configuration 65...
... negotiation.
In Example 4-6, rxspeed and txspeed are shown as separate commands. The speed command,
however, sets both transmit and receive speeds and locks the speed between the modem and the
DTE ... understands and sends in kind but does not
initiate the compression.
The encapsulation ppp command declares the encapsulation method for the interface.
The bandwidth 38 command tell...
... negotiation.
In Example 4-6, rxspeed and txspeed are shown as separate commands. The speed command,
however, sets both transmit and receive speeds and locks the speed between the modem and the
DTE ... understands and sends in kind but does not
initiate the compression.
The encapsulation ppp command declares the encapsulation method for the interface.
The bandwidth 38 command tell...
... IOS-based
commands, and set-based, command-line interface (CLI) commands. The IOS-based
commands (found in Catalyst 1900/2820, 2900XL, and 3500XL) are similar to many IOS
commands used on Cisco ... Street
Indianapolis, IN 46290
Cisco CCNP Switching Exam
Certification Guide
Tim Boyles and Dave Hucaby, CCIE #4594
x
Chapter 3
Basic Switch and Port Configuration 65...
... translation and applications; configuration com-
mands and system/network impact; and LAN/WAN interfaces, capa-
bilities, and applications.
Designing, configuring, installing, and verifying ... new certifications, and how do they help you get your CCIE?
Cisco Certified Network Associate (CCNA) 2.0
The CCNA certification is the first certification in the incremental l...