Design of analog CMOS integrated circuits

Design of analog CMOS integrated circuits

Design of analog CMOS integrated circuits

... the attributes of the circuit in this section, many advantages of the cascode topology over a simple common-source stage become evident. First, let us study the bias conditions of the cascode. ... input signal of a common-gate stage may be a current. We also know that a transistor in a common-source arrangement converts a voltage signal to a current signal. The cascade of a...
Ngày tải lên : 09/01/2014, 17:14
  • 706
  • 663
  • 1
Theory and Design of Electrical and Electronic Circuits

Theory and Design of Electrical and Electronic Circuits

... impedance Response of width and phase of a transfer Amplifier of simple syntony Design Amplifier multi-stages of same simple syntony Design Amplifier multi-stages of simple syntonies, for maximum plain Design Amplifier ... voltage of PINCH-OFF or "strangulation of the channel" defined in the curves of exit of the transistor, whose module agrees numerically...
Ngày tải lên : 23/10/2013, 16:15
  • 493
  • 797
  • 6
Electronics - Theory and Design of Electrical and Electronic Circuits

Electronics - Theory and Design of Electrical and Electronic Circuits

... the quality of the wave although it worsens the amplitude of the oscillation. Type bridge of Wien With the implementation of any circuit amplifier that completes the conditions of an AOV, ... logically of the Q 0ef ) bigger possible (that can replace it for a crystal and a crash of RF in derivation) L 0 = R 0 = what will allow us to have idea of the half value...
Ngày tải lên : 27/10/2013, 16:15
  • 493
  • 734
  • 2
SAP2000 Integrated Finite Elements Analysis and Design of Structures

SAP2000 Integrated Finite Elements Analysis and Design of Structures

... Span Loads Used In SAP2000 Model Roof Beams 39, 40, 51, 52 0.40 klf DL 0.12 klf LL Roof Beams 41/44, 42, 47/50, 49 Roof Beams 45, 46 0.48 klf DL 0.24 klf LL Roof Beams 43, 48 Second Floor Beams ... Options area, accept the Push to Displacement Of value of 0.96 feet. Note: The Push To Displacement Of value defaults to 0.04 times the Z coordinate of the highest joint in the model. Note...
Ngày tải lên : 06/09/2012, 15:56
  • 127
  • 1.5K
  • 2
Design and Simulation of A CMOS-MEMS Accelerometer

Design and Simulation of A CMOS-MEMS Accelerometer

... is one of the major sources of offset. The sensor outputs have an offset of about 25mV, which saturates the preamplifier. In experiments, the offset is cancelled by applying a DC voltage of about ... response of the sensor orientation with respect to gravity. due to self-test exitation of ~4g amplitude. Figure 5.8: Spectrum of amplitude-modulated signal. peak of driving forc...
Ngày tải lên : 27/10/2013, 23:15
  • 40
  • 588
  • 1
Tài liệu Design And Simulation Of A Cmos-Mems Accelerometer doc

Tài liệu Design And Simulation Of A Cmos-Mems Accelerometer doc

... capacitance of homoge- V s+ V s- Proofmass V m- V m+ Anchor Rigid frame Springs V s+ V s- V m- V m+ (a) symmetric design (b) common-centroid design Figure 2.9: Schematics of two sensor designs C gap C m ... bending of the beams, due to lateral residual stress gradient in the beam. In accelerometer design, lateral bending of beams can cause offset. Figure 2.5 shows finite element...
Ngày tải lên : 22/12/2013, 08:16
  • 40
  • 580
  • 0
Tài liệu Integrated Circuits A Design Perspective pptx

Tài liệu Integrated Circuits A Design Perspective pptx

... Simulated response EE141 1 © Digital Integrated Circuits 2nd Introduction Digital Integrated Digital Integrated Circuits Circuits A Design Perspective A Design Perspective Introduction Introduction Jan ... Digital Integrated Circuits 2nd Introduction The First Integrated Circuits The First Integrated Circuits Bipolar logic 1960’s ECL 3-input Gate Motorola 1966 EE1...
Ngày tải lên : 23/12/2013, 03:16
  • 51
  • 458
  • 2
Foundations of analog and digital electronic circuits

Foundations of analog and digital electronic circuits

... of several resistances including those of the wires and the bulb in series. Our lumped circuit abstraction and the resulting Kirchhoff’s laws allow us to calculate the equivalent resistance of ... reciprocal of R P is given in terms of R 1 , R 2 , R 3 , R N as 1 R P = 1 R 1 + 1 R 2 + 1 R 3 +··· 1 R n . (2.98) The equivalent resistance of N resistors in parallel is yet another exam...
Ngày tải lên : 09/01/2014, 17:03
  • 1K
  • 1.8K
  • 0
Tài liệu Novel Design of an Integrated Pulp Mill Biorefinery for the Production of Biofuels for Transportation pot

Tài liệu Novel Design of an Integrated Pulp Mill Biorefinery for the Production of Biofuels for Transportation pot

... demand of 4.5 GJ of steam per ton of pulp and 155 kWh/ton of pulp. [10, 14, 16] If the paper mill is located adjacent to the pulp mill, this stage can be ignored saving a large amount of energy. ... will be important to consider pretreatment requirements Novel Design of an Integrated Pulp Mill Biorefinery for the Production of Biofuels for Transportation EGEE 58...
Ngày tải lên : 26/02/2014, 14:20
  • 105
  • 518
  • 0

Xem thêm

Từ khóa: