... chapter six seals, gaskets and sealants 95 Oil pan gaskets Manifold gaskets Some oil pans and other parts are made as steel pressings These are not as rigid as cast parts and so require gaskets that ... assembly Handling and storing gaskets Gaskets should be handled and stored carefully to prevent damage which could render the gasket useless Some points to be observed...
... 001-016_May_chap 01 12/9/06 9:38 AM Page 3 Chapter Motor vehicle components Mechanical arrangements Sections of a motor vehicle The engine assembly Vehicle construction The drive train Transmissions ... enable various components which make up the mechanical section of a motor vehicle to be identified ■ The terms components, parts, units and items are all used in relation to...
... mechanical items Body repairs are usually carried out in a separate body repair workshop Automotive service procedures All automotive service jobs have certain procedures Procedures are ways of doing ... engine, transmission, body and so on An automotive mechanic must be able to refer to workshop manuals and interpret the information that they contain Workshop manuals have a conte...
... chapter three tools and their use Ring and open-end spanners are a combination, with a ring at one end and open jaws at the other The ring end can be used for loosening a bolt or nut and for final ... of a hand lever Tools for threading In the workshop, threads are cut by taps and dies A set of tools consists of a stock and dies and also a tap wrench and taps (Figure...
... Page 57 chapter four measuring and checking it until the anvil and the spindle are both lightly in contact with the cylinder walls Move the micrometer up and down slightly and also from side to ... 9:43 AM Page 59 chapter four measuring and checking figure 4.13 Sleeve and thimble markings on an inch micrometer To understand the scales, read the main scale first and then...
... and roller-type bearings, and by special antifriction metals in many plain bearings Application of friction to bearings An appreciation of friction and how it applies in actual bearings is helpful ... chapter five friction and bearings Technical terms Friction, static friction, sliding friction, rolling friction, fluid friction, surface-finish, traction, adhesion,...
... automatic In a workshop, people have to consider the safety of others as well their own They must understand general workshop safety requirements and, in particular, the need for safety when operating ... or be dropped Safety footwear is designed with reinforced toecaps to provide protection against these types of accidents ■ Open or soft footwear should not be worn in the worksho...
... 4D•2 Electronic fuel injection system General information and precautions General information From the 1990 model year, an Electronic Fuel Injection (EFI) system controlled by the Electronic ... Disconnect the fuel return hose from the regulator Be prepared for fuel spillage and Electronic fuel injection system 4D•3 Disconnect the fuel supply hose from the...
... Hickman and Reaves (20 03) Figure 2. 2—Number and Average Size of Local Police Departments and Number of Officers in 20 00 16 Protecting Emergency Responders Summary The large number of small emergency ... of Firefighters in 20 00 13 2. 2 Number and Average Size of Local Police Departments and Number of Officers in 20 00 15 2. 3 Number of Fire Department...
... from the null hypothesis (that residents of all three streets would have similar 21 World Transport Policy and Practice Volume 17.2 June 2011 numbers ... University Sustainability Policy (CUSP) Institute Perth, Western Australia Email: kenworthy@em.uni‐frankfurt.de World Transport Policy and Practice Volume 17.2 June 2011 Referenc...