... 2006 Acquisition and analysis of Langmuir probe characterization for ECR plasma Indian J Phys 80: 1011–1015 Jain S K, Jain A, Hannurkar P R, Kotaiah S 2007 Characterization of plasma parameter, ... distance for (a) mirror magnetic field, and (b) flat magnetic field the magnetic field can cause diffusion of the plasma particles to the wall of the plasma ch...
... characteristics of the fabricated SiNWs solar cell under dark and light conditions the thickness of Si base substrate more thinly For improvement of conversion efficiency of the SiNWs solar cells, the ... performance Therefore, further reduction of the reflectance will be expected from the optimization of the synthesis conditions of SiNWs For analysis of the electri...
... the electrical and gas sensing behavior of ZnO nanowires Fig Characteristics of In3 O2 nanowires: (a) SEM image of In3 O2 nanowires, (b) TEM image of nanowire 70 nm in width, and (c) ED pattern ... image of a nanowire, and (e) linescan of the HAADF signal (solid line) and numerical fit of the shape of the nanowire (dashed line) As both composition and phase ca...
... on working electrodes made of highly ordered anodic titanium oxide nanotube arrays of varied tube length directly formed on Ti foil The lengths of these ATO NT were controlled from to 41 µm while ... Because of the robust structure of the NT arrays and the loose structure of the surface debris, the unwanted deposits on the ATO surface Anodic TiO2 Nanotube Arra...
... Synthesis and characterization of CuO nanowires by a simple wet chemical method Anita Sagadevan Ethiraj1 and Dae Joon Kang*1 BK21 Physics Research Division, Department of Energy Science, ... djkang@skku.edu Abstract We report a successful synthesis of copper oxide nanowires with an average diameter of 90 nm and lengths of several micrometers by using...
... processing of large-scale graphene Nat Nanotech 2009, 4:25-29 doi:10.1186/1556-276X-7-53 Cite this article as: Kim et al.: Fabrication and characterization of carbon-based counter electrodes prepared by ... graphene, SWNTs, and graphene-SWNT composites could perform sufficiently well as counter electrodes for DSSCs Figure Nyquist plot of DSSCs Nyquist plot of D...
... processing of large-scale graphene Nat Nanotech 2009, 4:25-29 doi:10.1186/1556-276X-7-53 Cite this article as: Kim et al.: Fabrication and characterization of carbon-based counter electrodes prepared by ... graphene, SWNTs, and graphene-SWNT composites could perform sufficiently well as counter electrodes for DSSCs Figure Nyquist plot of DSSCs Nyquist plot of D...
... Synthesis and characterization of CuO nanowires by a simple wet chemical method Anita Sagadevan Ethiraj1 and Dae Joon Kang*1 BK21 Physics Research Division, Department of Energy Science, ... djkang@skku.edu Abstract We report a successful synthesis of copper oxide nanowires with an average diameter of 90 nm and lengths of several micrometers by using...
... Fabrication and characterization of well-aligned and ultra-sharp silicon nanotip array Chi-Chang Wu*1,2, Keng-Liang Ou1,2, and Ching-Li Tseng1 Graduate Institute of Biomedical Materials and ... process, and the exposed silicon substrate is etched away to form the nanotip The field emission property of the ultra-sharp nanotip is measured, and the turn-on f...
... integration into heterojunction silicon wafer solar cells and subsequently the modelling of heterojunction and hybrid heterojunction silicon wafer solar cells that utilize these films Three key ... monocrystalline/multicrystalline solar cells, thin- film solar cells, organic solar cells, tandem cells, concentrator cells and varying choice of mat...
... Comparison of separation performance for hollow fiber membranes between the O2/N2 mixed gas and pure gas measurements……… … 245 Table B.3 Comparison of separation performance for hollow fiber membranes ... FABRICATION AND CHARACTERIZATION OF COMPOSITE MEMBRANES FOR GAS SEPARATION JIANG LANYING (B Sci., Wuhan University, P R China) A THESIS SUBMITTED FOR...
... 3/ (#CpD), $ = L2/(%2&) and & = k/(#Cp) Equation (3. 3) should be satisfied for the thermal conductivity calculated to be within +/ -3. 5% of the actual value < 2'$ < (3. 3) The parameters of the lock-in ... working frequency for the Ge nanowire sample was 1000 Hz, 0. 03 s of time constant was sufficient for stability 3. 11 Ceramic heater setup for temperature dependence c...
... roughness of the nanowires and act as a form of phonon-scattering elements at several length scales If precipitates are incorporated carefully, the k of Ge Thermal Conductivity of GeNw and SiNw 77 nanowires ... resistivity of the GeNw were measured and extracted accordingly as below Electrode to 2, to and to : 0. 349 ! m Electrode to and to : 0 .41 3 ! m Electrode to :...