... approximately
10 parts decontamination solution to every one part spilled TDI.
Suggested Formulation for Decontamination Solution
% by Weight
Water 75
Nonionic Surfactant
a
20
n-propanol 5
a
e.g., ... well-ventilated place.
5. Discard all contaminated clothing. Decontaminate personnel and equipment
using approved procedures.
Decontamination of empty containers:
1. Spray or pour 1 5...
... Mech. 18 , 4 05 413 .
Mallock, A. (18 81 82) The action of cutting tools. Proc. Roy. Soc. Lond. 33, 12 7 13 9.
Merchant, M. E. (19 45) Mechanics of the metal cutting process. J. Appl. Phys. 16 , 318 –324.
Oxley, ... Proc. I Mech. E. Lond.
209Pt.J, 13 1 13 6.
Weiner, J. H. (19 55 ) Shear plane temperature distribution in orthogonal cutting. Trans ASME 77,
13 31 13 41.
Williams, J. A. (1...
... plane-slider is as follows:
W ¼
6mULB
2
h
2
2
1
b 1
2
ln b
2ðb 1
b þ 1
!
ð4 -19 Þ
where b is the ratio of the maximum and minimum film thickness, h
2
=h
1
.A
similar derivation can be followed ... pressure wave along the x direction (between
x ¼ h
1
=a and x ¼ h
2
=a):
p ¼
6mU
a
3
ðh
1
axÞðax h
2
Þ
ðh
1
þ h
2
Þx
2
ð4 -17 Þ
At the boundaries h ¼ h
1
and h ¼ h
2
, t...
... section 5. 8 .5.
Figure 5 - 15 Conformance to limits of
size for a width-type feature
Figure 5 -16 Size limit boundaries
control circularity at each cross section
5- 24 Chapter Five
5. 6.2 .1 Modifier ... Rule #1 mandates a ∅ .50 2 boundary of perfect form at MMC (envelope)
Figure 5- 21 Rule #1 specifies a boundary
of perfect form at MMC
Geometric Dimensioning and Tolerancing 5...
... this system, and the total momentum
column of mercury 1 centimeter high, having a
of the system is zero. Also known as center
density of 13 .59 51 grams per cubic centimeter,
of momentum coordinate ... ko
¯
trate of 1 centiliter per second at a pressure of
1 millitorr, or to approximately 1. 33322 ϫ 10
Ϫ6
haŋиər dı
¯
}
coaxial
[
MECH
]
Sharing the same axes.watt. { ¦klu
¨
¦sek }...
... machine is shown in
Figure 5 .12
FIGURE 5 .10 : DeVlieg tooling for single- or multi-spindle automatic lathe (Courtesy:
National Acme Co., Div. DeVlieg-Bullard Inc.)
FIGURE 5 .11 : Conventional single-spindle ... slide,
rear tool slide, and turret, as shown in
Figure 5 .11 . A conventional single spin-
dle automatic screw machine is shown
in Figure 5 .11
The feed rates an motion o...