... location sensing using RFID. 1) Deploying RFID tags at fixed locations and
RFID readers attached to moving objects (Willis, 2004). Each tag represents a reference point
in the space, and a reader ... Iteration, SVC, and Iterative SVC algorithms
Current Trends and Challenges in RFID
358
tag and node. The experiments show that tracking accuracy is improved and...
... problem is known
324
Current Trends and Challenges in RFID
Current Trends and Challenges in RFID
344
2
0
3/2
0
2
2
2
sin( )
d
4
cos( ) sin( )
RR
R
y
RR
IN
zr
B
xr yr z
... and Challenges in RFID
Current Trends and Challenges in RFID
348
Taking into consideration the fact that the stabilizer is on input to th...
... PIN
Inventoried
Killed
inoperative
reader sends “kill” command
Current Trends and Challenges in RFID
396
and bag such that tracking is still possible by associating these kinds of particular ... blocking
Inventoried
just release general
information
Inventoried
release more specific
information
close interrogating
far interrogating
Current Trends and Challenges...
... obtained from orders@intechweb.org
Current Trends and Challenges in RFID, Edited by Cornel Turcu
p. cm.
ISBN 978-953-307-356-9
Current Trends and Challenges in RFID
18
The gain ...
Similarly,
S
12
and S
22
can be obtained by measuring the incident, the reflected and the
transmitted signals at the output when the input is terminated in
Z
0
. Sin...
... = v
GS
- V
t
, the current becomes independent of v
DS
.
Current Trends and Challenges in RFID
32
a. Both LO and input signals are balanced, providing both LO and input rejection at the ... follower for
output matching, but has passive output matching network, which consists of bandpass
filter and impedance inverting scheme.
Current Trends and Challenges...
... area and
simple circuit topology.
Current Trends and Challenges in RFID
70
Figure 17 shows the main current and voltages values used to estimate MP
PASS
and MN
FOLL
geometric aspects.
For ... Frequency Integrated Circuit Design, Artech House Inc, ISBN
1607839792.
Ziel, A. (1986) Noise in Solid State Devices and Circuits, John Wiley and Sons, ISBN
0471832...
... other hand, it is encumbering and not well-suited
Current Trends and Challenges in RFID
80
2. Minimum emitter area for matched transistors, otherwise there will be a degradation in
the current ... to V
IN
42.8[%]
42.3[%]
T
SET
@ 0,1% 14.87[μs] 18.6[μs]
OTA dominant pole 130 [H
Z
] 126[H
Z
]
Table 6. Main LVR simulated and measured parameters.
Current Tr...
... still not satisfied after a printing running on the machine shown in the Fig. 6(a),
feeding the printed sheets into machine from beginning again for multiple printing can be
considered. Fig. ... Raimondo, P. Ramoino and M. Robello, “A Single-
Pinhole Confocal Laser Scanning Microscope for 3-D Imaging of Biostructures,”
IEEE Engineering in Medicine and Biology Magazine, Vol. 18, Iss...
... research in nature and aimed to investigate the process
consistency and capability of printing RFID tag antennas via the screening printing process
Screening printing using Ag ink with ...
substrates, and
3. to determine the optimal substrates for RFID tags using screen printing technology with
conductive inks, in terms of process capability.
Current Trends and...
... obtaining AMC designs that can be easily integrated in low
profile antennas and microwave and millimeterwave circuits, recent research efforts focus
Current Trends and Challenges in RFID ... testing again the NF Cube 2 tag
and the two FF, Thin Propeller and Dog Bone, tags. The histogram clearly demonstrates that
Current Trends and Challenges in RFID
1...