... result list of load cases, superposition files and
influence lines
3.64 Version 8.38.03
• Use of combination codes “SupOrX” and “SupAndX” for superposition files cor-
rected
• New command “PLSCFAC” ... 8.38.04
• Width and height of composite section for wind load corrected.
• Extended printout for shear check (AAHSTO)
• Minor changes and error corrections in import/expo...
... must understand the assumptions of the program and must apply engineering
knowledge and skill to independently verify the results.
Copyright
The computer programs RM2000, GP2000 and all ... thoroughly tested and used.
The user accepts and understands that no warranty is expressed or implied by the devel-
opers or the distributors on the accuracy or the reliability of...
... Definition of loading and construction
stages.
"RECALC Definition of calculation parameters and start of the calculation.
"RESULTS Viewing of results and creating of output files (plots and ... the icons at the top of the RM2000 screen), write the sequence
of commands and save it as ‘filename.tcl’.
The summary and the syntax of the commands to be sp...
... LUTS and/ or BPH). Fur-
thermore, those with OAB had a worse quality of life
score. Mean quality of life score for those with OAB
was 3.4 of 6, and those without OAB 1.6. Thus, the
48% of men ... quality of
life score. Mean quality of life score for those with
OAB was 3.4 of 6, and those without OAB 1.6. Fur-
thermore, 59% reported urge incontinence, 76% ur-
gency, 90%...
... complementary forms of assessment take
place: the assessment of the significance of the findings and the determination of the causes (of
increased performance or of the lack of performance where performance ... Evaluation of the impact of the policy what is the economic and what is the economic
and social impact of the policy?
• Evaluation of the effectiveness...
... development of this research work, allowing
components of computational dynamic and laboratorial investigation associated to the performance of
turbines of several types to be developed and compared. ... Variation of discharge and binary with two and three pistons of double or single effect out of
phase of 90º and 120º
3.2 Positive displacement pumps
This...
...
kg/m
2
/day and 13.335 kg/m
2
/day for fresh water at a distillate efficiency of 50.989% and 24.245% and
overall thermal efficiency of 81.171% and 40.362% are found in the months of March and December ... in the month of March of 955.56 W/m
2
at 13:00 and minimum in December of 705.56 W/m
2
at 12:00. Whereas ambient temperature is
maximum of 36.1
o
C at 13:00 i...
... number of shims under the pump body. The
standard setting of the engine used for test is with three shims to give standard injection timing of 23
o
International Journal of Energy and Environment ... sensor, No of channels 2, Communication RS232
Software “Enginesoft LV” Engine performance analysis software (on NI
platform)
2.3 Experimental procedure
The performance...