Quản trị mạng Lab 4-5 - RIP & IGRP

2 357 5
Quản trị mạng Lab 4-5 - RIP & IGRP

Đang tải... (xem toàn văn)

Thông tin tài liệu

Quản trị mạng Lab 4-5 - RIP & IGRP

CCNA LAB No. 4-5 : CONFIGURE Static route – RIPIGRP Lab time: 1 Task 2: RIP1. Đặt địa chỉ cho router: (Ví dụ: router 3)Router> enable Router# config terminal Router# interface loopback 0 Router(config)# ip address 3.3.3.3 255.255.255.255 Router(config)# ip address 10.10.10.3 255.255.255.0 Router(config)# ip address 192.168.168.3 255.255.255.02. Enable RIP on each router in your network. To enable RIP, use the following commands in global configuration mode:Router> enableRouter# config terminal Router(config)#router rip : bật giao thức rip lên Router(config-router)#network network-number : gõ các mạng kết nối trực tiếp với routerVí dụ: với router R3:Router(config-router)#network 3.0.0.0Router(config-router)#network 10.0.0.0Router(config-router)#network 192.168.168.0www.ipmac.com.vn 1 3. Dùng các lệnh dưới đây để kiểm tra kết quả: Router(config)#exit Router#show ip route Router#show ip protocol Router#debug ip ripwww.ipmac.com.vn 2 . CCNA LAB No. 4-5 : CONFIGURE Static route – RIP – IGRP Lab time: 1 Task 2: RIP1 . Đặt địa chỉ. Router(config)#router rip : bật giao thức rip lên Router(config-router)#network network-number : gõ các mạng kết nối

Ngày đăng: 13/11/2012, 10:56

Tài liệu cùng người dùng

  • Đang cập nhật ...

Tài liệu liên quan