HƯỚNG DẪN THIẾT KẾ 3D TRONG SOLIDWORKS

189 809 0
HƯỚNG DẪN THIẾT KẾ 3D TRONG SOLIDWORKS

Đang tải... (xem toàn văn)

Tài liệu hạn chế xem trước, để xem đầy đủ mời bạn chọn Tải xuống

Thông tin tài liệu

Tài liệu này sẽ hướng dẫn các bạn một cách chi tiết và đầy đủ nhất về thiết kế các đối tượng 3D trong Solidworks. Solidworks là phần mềm thiết kế cơ khí 3D, chạy trên hệ điều hành Windowns. Solidworks được phát triển bởi Dassault Systèmes Solidworks Corp, một công ty con của Dassault Systèmes, SA (Vélizy, Pháp). Solidworks hiện đang được sử dụng bởi hơn 2 triệu kỹ sư và nhà thiết kế ở mức hơn 178.000 công ty trên toàn thế giới. Solidworks đang là đối thủ cạnh tranh trực tiếp với Autodesk Inventor.

[...]... its Z-axis is in vertical This is common in plant design system However, this is different from the part design in SolidWorks, in which Y-axis is commonly in vertical Please note that its Z-axis is in vertical 7 w w w s oli d pl a n t3 d c o m Now please look at model viewing We can use SolidWorks feature called Orientation to create views from different viewpoints, which we have previously used for... order to correctly sketch before and then generate later, we can disable them at this point As seen below, we have many types of Snaps for pipe routing to select from These Snaps are in fact Snaps in SolidWorks Additionally, as below, we also have options of Slope feature This is important for pipe routing in slope We can set it as proportion, for example, 1:100 or 1:50 When we want to use it, just... button Next, please look at the third tab, which is Model Setup This tab is for Snap settings frequently used in the project for model making These Snaps are in fact the Snaps that have already been in SolidWorks, but we have brought them into SolidPlant to be able to more easily set them Next, below is Shaded Quality, which we can set shade and wireframe for display quality However, this depends on... operating pressure, as well as material grades used and specified in the pipe spec So it is necessary to consider making the piping specification in accordance with the systems that we will design in pipe 3D routing Chapter 3-2 Introduction concept to making the pipe spec Now we will learn the concept of how to make the piping spec I will begin with the concept of the SolidPlant Program SolidPlant has catalogs

Ngày đăng: 20/04/2015, 07:09

Từ khóa liên quan

Mục lục

  • Intro-ch1

  • contents

  • ch2

  • ch3

  • ch4

  • ch5

  • ch6

  • ch7

  • ch8

  • ch9

  • ch10

  • ch11

  • ch12

  • ch13

  • Lege pagina

Tài liệu cùng người dùng

  • Đang cập nhật ...

Tài liệu liên quan