... if ({c,d} != 2& apos;b01) (c,d *> out) = 13; endspecify and a1(e, a, b); and a2(f, c, d); and a3(out, e, f); endmodule Rise, fall, and turn-off delays Pin-to-pin timing can also ... endspecify and a1(e, a, b); and a2(f, c, d); and a3(out, e, f); endmodule The full connection is particularly useful for specifying a delay between each bit of an input vector and every ... t_x0, t_xz, t_zx ); Min, max, and typical delays Min, max, and typical delay values were discussed earlier for gates in Section 5 .2. 2, Min/Typ/Max Values. Min, max, and typical values can also...