0
  1. Trang chủ >
  2. Thể loại khác >
  3. Tài liệu khác >

Handbook of food engineering 2nd ed d heldman 2007

Handbook of Mechanical Engineering Calculations P1

Handbook of Mechanical Engineering Calculations P1

... reserved Any use is subject to the Terms of Use as given at the website Source: HANDBOOK OF MECHANICAL ENGINEERING CALCULATIONS SECTION MODERN POWER-PLANT CYCLES AND EQUIPMENT CYCLE ANALYSES 1.4 ... estimation of various frequencies Use the listing of C values shown below to determine the mode of vibration Note that C is a factor determined by the end conditions of the tube bundle Mode of vibration ... and off-design performance of an HRSG, such as that in Fig 16, under different conditions of exhaust flow, temperature, and auxiliary firing without delving into the mechanical design aspects of...
  • 124
  • 633
  • 1
Handbook of Mechanical Engineering Calculations P2

Handbook of Mechanical Engineering Calculations P2

... (0.28 kg) of water per pound (kg) of dry air Since the water content of the air is a function of the partial pressures, (0.622) (0.5067) / [(2 ϫ 0.5067)] ϭ 0.673 lb of water per lb of dry air ... m2) of condensing surface, a circulating-water flow rate of 10,000 gal / (630.8 L / s), 3⁄4-in (1.9-cm) no 16 BWG tubes, a water flow rate of ft / s (2.1 m / s), external friction of 20 ft of water ... a capacity of 8000 gal (30,280.0 L), and the steam space has a capacity of 30,000 gal (113,550.0 L) of water Downloaded from Digital Engineering Library @ McGraw-Hill (www.digitalengineeringlibrary.com)...
  • 28
  • 692
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P3 pdf

Tài liệu Handbook of Mechanical Engineering Calculations P3 pdf

... (0.0283 cu m) of natural gas; 1300 cu ft of air (36.8 cu m) per gal (0.003785 cu m) of No fuel oil; 1450 cu ft of air (41 cu m) per gal of No fuel oil; 1500 cu ft of air (42.5 cu m) per gal of No fuel ... combustion of lb (0.45 kg) of coal ϭ sum of nitrogen and oxygen required ϭ 8.4228 ϩ 2.5444 ϭ 10.9672 lb (4.975 kg) of air per pound (kilogram) of coal burned Compute the weight of the products of combustion ... and increases the weight of the products of combustion per pound (kilogram) of coal burned Therefore, the weight of the products of combustion is the sum of the weight of the combustion products...
  • 24
  • 744
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P4 pptx

Tài liệu Handbook of Mechanical Engineering Calculations P4 pptx

... lb of moisture per lb fuel burned; Ma ϭ lb of moisture per lb of dry air to furnace; Cb ϭ lb of carbon burned per lb of fuel burned ϭ C ϭ RCr; Cr ϭ lb of combustible per lb of refuse; R ϭ lb of ... Related Calculations Developing the performance characteristics of each piece of equipment as a function of load is the key to determining the mode of operation and loading of each type of steam ... Marks—Standard Handbook for Mechanical Engineers for a comprehensive tabulation of the densities of various materials PROPERTIES OF A MIXTURE OF GASES A 10-ft3 (0.3-m3) tank holds lb (0.5 kg) of hydrogen...
  • 80
  • 634
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P5 pdf

Tài liệu Handbook of Mechanical Engineering Calculations P5 pdf

... output of the existing system is increased, as noted, because of increasing flow to the steam turbine’s condenser This increased output offsets the cost of interconnection to the boiler Related Calculations ... the number of tubes per pass Assume the heater has only one pass, and compute the number of tubes required Once the number of tubes is known, a decision can be made about the number of passes ... (number of tubes per pass)(passes)(area per ft of tube) Or, tube length for pass ϭ 92.7 / [(14)(1)(0.1636)] ϭ 40.6 ft (12.4 m) The area per ft of tube length is obtained from a table of tube...
  • 16
  • 616
  • 1
Tài liệu Handbook of Mechanical Engineering Calculations P6 pdf

Tài liệu Handbook of Mechanical Engineering Calculations P6 pdf

... average heat of vaporization of 1000 Btu / lb (2330 kJ / kg) of steam, this exhaust gas flow could generate 8,880,000 / 1000 ϭ 8880 lb / h (4032 kg / h) of steam If oil with a heating value of 145,000 ... mid-rise of ce buildings Title 24 is a section of the State of California Administrative Code that deals with energy-conservation standards for construction applicable to of ce buildings A summary of ... introduced every year *Elliott, Standard Handbook of Power Plant Engineering, McGraw-Hill, 1989 Downloaded from Digital Engineering Library @ McGraw-Hill (www.digitalengineeringlibrary.com) Copyright...
  • 44
  • 734
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P7 docx

Tài liệu Handbook of Mechanical Engineering Calculations P7 docx

... this handbook Once the required flow rate is determined, apply a suitable factor of safety The value of this factor of safety can vary from a low of percent of the required flow to a high of 50 ... Companies All rights reserved Any use is subject to the Terms of Use as given at the website Source: HANDBOOK OF MECHANICAL ENGINEERING CALCULATIONS SECTION PUMPS AND PUMPING SYSTEMS PUMP OPERATING ... point of crossing of the two-pump curve and the system-head curve is at the required value of 80 gal / (7.4 L / s) and 13-ft (3.96-m) head because it was so planned But the point of crossing of...
  • 86
  • 916
  • 14
Tài liệu Handbook of Mechanical Engineering Calculations P8 doc

Tài liệu Handbook of Mechanical Engineering Calculations P8 doc

... surges result The amplitude of the pressure surge is a function of the rate of change in the velocity of the mass of fluid This procedure shows how to compute the amplitude of the pressure surge with ... stainless-steel pipes of different diameters, Fig 3, conveys 40 gal / (2.5 L / s) of water The length of each section of Downloaded from Digital Engineering Library @ McGraw-Hill (www.digitalengineeringlibrary.com) ... factor of for traps installed between a boiler and the end of a steam main; traps at the end of a long steam main or ahead of pressure-regulating or shutoff valves usually have a safety factor of...
  • 136
  • 560
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P9 pdf

Tài liệu Handbook of Mechanical Engineering Calculations P9 pdf

... curve of a typical air motor Note how a built-in governor can change the shape of the curve by limiting the maximum speed of the air motor (Product Engineering) Downloaded from Digital Engineering ... (339.6 m3 / min) of air at a pressure of 14 lb / in2 (abs) (96.46 kPa) and a temperature of 60ЊF (15.6ЊC) Downloaded from Digital Engineering Library @ McGraw-Hill (www.digitalengineeringlibrary.com) ... ϭ 2.91 in (7.4 cm) Related Calculations The air consumption of power tools is normally expressed in ft3 / of free air at sea level; the actual capacity of any type of air compressor is expressed...
  • 44
  • 648
  • 1
Tài liệu Handbook of Mechanical Engineering Calculations P11 doc

Tài liệu Handbook of Mechanical Engineering Calculations P11 doc

... FACILITIES ENGINEERING TABLE Results of Trial Calculations 1st Trial Number of tubes Shell diameter, in Baffle spacing, in Product of factors: Tubeside Shellside Tube wall Fouling Total sum of products ... tube manufacturer’s engineering data show that a finned tube of these dimensions has 5.8 ft2 of area per linear foot (1.8 m2 / lin m) of tube To compute the linear feet L of finned tubing required, ... heat Hm Btu required to melt a solid is Hm ϭ (weight of solid melted, lb)(heat of fusion of the solid, Btu / lb) Since the heat of fusion of lead is 10 Btu / lb (23.2 kJ / kg), Hm ϭ (600)(10)...
  • 86
  • 620
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P12 pdf

Tài liệu Handbook of Mechanical Engineering Calculations P12 pdf

... is the work of Norman R Sparks, Professor and Head, Department of Mechanical Engineering, The Pennsylvania State University, and Charles C DiLio, Associate Professor of Mechanical Engineering, ... is the work of Norman R Sparks, Professor and Head Department of Mechanical Engineering, The Pennsylvania State University, and Charles C DiLio, Associate Professor of Mechanical Engineering, ... FACILITIES ENGINEERING This procedure is the work of Norman R Sparks, Professor and Head, Department of Mechanical Engineering, The Pennsylvania State University, and Charles C DiLio, Associate Professor...
  • 80
  • 512
  • 0
Tài liệu Handbook of Corrosion Engineering P2 pdf

Tài liệu Handbook of Corrosion Engineering P2 pdf

... Filiform corrosion Filiform corrosion is a localized form of corrosion that occurs under a variety of coatings Steel, aluminum, and other alloys can be particularly affected by this form of corrosion, ... lowest concentration of oxygen at the head Coated alloy Tail Back of head X Front of head Head Direction of propagation Figure 1.10 Illustration of the filament nature of filiform corrosion 0765162_Ch01_Roberge ... the head of the corrosion filament (Fig 1.11) For iron, pH values at the front of the head of to and a potential of close to Ϫ0.44 V (SHE) have been reported In contrast, at the back of the head,...
  • 20
  • 405
  • 2

Xem thêm

Từ khóa: handbook of mechanical engineeringhandbook of food and beverage fermentation technologyhandbook of offshore engineering volume2principles of marketing engineering 2nd edition ebookprinciples of marketing engineering 2nd edition pdfprinciples of marketing engineering 2nd editionhandbook of offshore engineeringmiller r w 1997 roller compaction technology in parikh d m ed handbook of pharmaceutical granulation technology marcel dekker inc new york pp 99 150the standard handbook of engineering calculationshandbook of image and video processing by ed alan c bovikarbib michael a ed 1995 the handbook of brain theory and neural networksthe handbook of brain theory and neural networks 2nd editionhandbook of image and video processing by ed alan c bovik pdfstandard handbook of engineering calculations hicksstandard handbook of engineering calculations 3rd editionBáo cáo quy trình mua hàng CT CP Công Nghệ NPVGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitPhát triển mạng lưới kinh doanh nước sạch tại công ty TNHH một thành viên kinh doanh nước sạch quảng ninhNghiên cứu tổng hợp các oxit hỗn hợp kích thƣớc nanomet ce 0 75 zr0 25o2 , ce 0 5 zr0 5o2 và khảo sát hoạt tính quang xúc tác của chúngChuong 2 nhận dạng rui roKiểm sát việc giải quyết tố giác, tin báo về tội phạm và kiến nghị khởi tố theo pháp luật tố tụng hình sự Việt Nam từ thực tiễn tỉnh Bình Định (Luận văn thạc sĩ)Quản lý nợ xấu tại Agribank chi nhánh huyện Phù Yên, tỉnh Sơn La (Luận văn thạc sĩ)Tăng trưởng tín dụng hộ sản xuất nông nghiệp tại Ngân hàng Nông nghiệp và Phát triển nông thôn Việt Nam chi nhánh tỉnh Bắc Giang (Luận văn thạc sĩ)Giáo án Sinh học 11 bài 15: Tiêu hóa ở động vậtGiáo án Sinh học 11 bài 15: Tiêu hóa ở động vậtGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtTrách nhiệm của người sử dụng lao động đối với lao động nữ theo pháp luật lao động Việt Nam từ thực tiễn các khu công nghiệp tại thành phố Hồ Chí Minh (Luận văn thạc sĩ)Chiến lược marketing tại ngân hàng Agribank chi nhánh Sài Gòn từ 2013-2015Đổi mới quản lý tài chính trong hoạt động khoa học xã hội trường hợp viện hàn lâm khoa học xã hội việt namHIỆU QUẢ CỦA MÔ HÌNH XỬ LÝ BÙN HOẠT TÍNH BẰNG KIỀMTÁI CHẾ NHỰA VÀ QUẢN LÝ CHẤT THẢI Ở HOA KỲ