... group
membership consists of only one neighbor.
A description can be added to a peer group or an individual neighbor using the neighbor { ip-
address | peer-group-name } description textcommand. ... is the highest IP address on the router, with preference given to loopback
addresses.
Now, you can examine the general configuration of BGP for all routers in a large-scale IP network...
... Professional Development Large-Scale
IP Network Solutions
Khalid Raza
Mark Turner
Publisher: Cisco Press
First Edition November 09, 1999
ISBN: 1-57870-084-1, 5 76 pages
CCIE Professional Development: ... Development: Large-Scale IP Network Solutions
is a core preparation textbook for the CCIE Routing and Switching
exam track. In addition to CCIE preparation...
... corruption. Routing in IP networks is usually based on an IP
destination address.
Figure 3-1. Packet Switching
59
Packet routers in IP networks are able to detect IP packet errors, but ... "Evolution of Data Networks.") Finally, this section examines the principles
of layering and regionalization of a large network into core, distribution, and access networks.
B...
...
router rip
network 131.108.0.0
interface serial 0
ip rip send version 1
ip rip receive version 1
interface fddi 1
ip rip send version 2
ip rip receive version 2
interface ethernet 1
ip rip ... connected networks
under the router RIPV1 statement for which you want to enable RIPV1 (see Figure 6- 13).
Figure 6- 13. Enabling RIPV1 on Different Networks
The configuration for...
... subnetted, 6 subnets, 2 masks
D 10.30.5.0/24 [90/21954 56] via 131.108.1.1, 00:00: 16, Serial 1/2
D 10.30 .6. 0/24 [90/21954 56] via 131.108.1.1, 00:00: 16, Serial 1/2
D 10.0.0.0/8 is a summary, 00:00: 16, ...
1:
Does RIPV2 have a larger infinity value than RIPV1?
A:
No. RIPV2 still has the maximum hop count of 16.
2:
By default, how frequently does a RIP router send updates?
A...
... ABR.
2 26
ip address 131.108.1.9 255.255.255.252
ip ospf network point-to-point
ip ospf cost 1 562
frame-relay interface-dlci 199
The Point-to-Multipoint Model
The point-to-multipoint ... connected to a stub network and a transit network. Therefore, the stub
network link ID is set to 192.1.4.0 (IP subnet address). The transit network link ID is set to
192.1.1.4 (IP...
... 4 msec
6 s2-1-1.paloalto-cr18.bbnplanet.net (131.119. 26. 9) [AS 1] 4 msec 8
msec 4 msec
7 h1-0.atteasylink.bbnplanet.net (131.119. 26. 1 26) [AS 1] 8 msec 8 msec
4 msec
8 205.174.74.1 86 [AS 5727] ... management environments.
As well as IP, SNMPv2 is standardized to run over IPX, AppleTalk, and CLNS networks.
However, given the global networking convergence on IP as a standard pr...