0
  1. Trang chủ >
  2. Thạc sĩ - Cao học >
  3. Kỹ thuật >

The immersed boundary method for the (2d) incompressible navier stokes equations LUANVAN TH s

The immersed boundary method for the (2d) incompressible navier stokes equations LUANVAN TH s

The immersed boundary method for the (2d) incompressible navier stokes equations LUANVAN TH s

... with separately.5.1.1 Immersed bodies with elastic boundariesThis is the class of flow problems Peskin had in mind when he developed the first IBMs [21]. His method solves the Navier- Stokes equations ... any stiffness parameter (as is the case in the continuous forcing methods), and that is ofcourse good news. But the repeated use of the smoothed distribution function to extend the forcing to the grid ... condition method Chapter 3 The Immersed Boundary Method 3.1 Definition The term Immersed Boundary Methods (also known as embedded boundary techniques) designates the class of boundary methods where the...
  • 122
  • 422
  • 0
Báo cáo hóa học:

Báo cáo hóa học: " A stabilized mixed discontinuous Galerkin method for the incompressible miscible displacement problem" pdf

... element method with the stabilizedmixed discontinuous Galerkin methods for the incompressible miscible displacementproblem in porous media. For the pressure equation, w e develop a mix ed, stabilized,discontinu ... estimators in this paper for the local space Pr,but the results also apply to the local space Qr (the tensor product of the polynomial spacesof degree less than or equal to r in each spatial ... Hk(Th)). We further assume that p, ∇p, cand∇c are essentially bounded. If the constant M for the cut-off operator is sufficiently large, then there exists a constant Cindependent of h such that(u...
  • 17
  • 400
  • 0
Development of the Quantitative PCR Method for Candidatus ‘Accumulibacter phosphatis’ and Its Application to Activated Sludge

Development of the Quantitative PCR Method for Candidatus ‘Accumulibacter phosphatis’ and Its Application to Activated Sludge

... Candidatus ‘Accumulibacter phosphatis’ in activated sludge samples was quantified using the quantitative PCR and the FISH methods respectively. The protocol for the quantitative PCR method is as described ... laboratory-scale and full-scale activated sludge samples were quantified both by the quantitative PCR method and by the FISH method. The quantification results by these two methods agreed satisfactorily, ... areas. RESULTS AND DISCUSSION Development of Quantitative PCR method Specificity of the primer set was evaluated based on the melting curve and the sequencing analysis. Melting peaks of the...
  • 7
  • 719
  • 0
Tài liệu Đề tài

Tài liệu Đề tài " Boundary regularity for the Monge-Amp`ere and affine maximal surface equations " docx

... system, we assume that ˆx is on the positivexn-axis, the origin is a boundary point, and Ω ⊂{xn> 0}. Suppose u(0)=0,Du(0) = 0. Then the arguments of the preceding sections apply, with θ =116n,and ... either the distancefrom the plane P = {zn=0} to the set {v<1}∩∂Ω is larger than C/K,or the angle θ1between the plane P and the plane {yn=0} satisfies (2.22). In the former case, by ... =(x1,xn), and the domains Dt, Ωtdenote the re-striction on the 2-plane.Assume the supremum ahis achieved at xh=(ah,ch). In the two dimen-sional case, the level set  := S h,ukis a curve...
  • 38
  • 330
  • 0
INTERNATIONAL STANDARD Microbiology of food and animal feeding stuffs — Horizontal method for the detection of Salmonella spp docx

INTERNATIONAL STANDARD Microbiology of food and animal feeding stuffs — Horizontal method for the detection of Salmonella spp docx

... to these products, may be used if absolutely necessary for justified technical reasons. Nevertheless, every attempt should be made to apply this horizontal method as far as possible. When this ... Dissolve the sodium chloride in the water. Adjust the pH, if necessary, so that after sterilization it is 7,0 ± 0,2 at 25 °C. Dispense quantities of the solution into flasks or tubes (6.9) so ... together with details of any incidents which may have influenced the results;  the results obtained. The test report shall also state whether a positive result was obtained only when using...
  • 34
  • 690
  • 0
Fundamentals of the finite element method for heat and fluid flow   lewis, nithiarasu,seetharamu

Fundamentals of the finite element method for heat and fluid flow lewis, nithiarasu,seetharamu

... degrees of freedom. The steps in the analysis of a discrete systemare as follows:Step 1: Idealization of system: System is idealized as an assembly of elementsStep 2: Element characteristics: The ... cpg, the specific heat of the gas; mw,themassof the wall of the bulb; cpw, the specific heat of the wall; hf, the heat transfer coefficientbetween the filament and the gas; hg, the heat ... without the permission inwriting of the Publisher. Requests to the Publisher should be addressed to the Permissions Department, JohnWiley & Sons Ltd, The Atrium, Southern Gate, Chichester,...
  • 356
  • 1,327
  • 2
Comparison between the Matrix Pencil Method and the Fourier Transform Technique for High-Resolution Spectral Estimation

Comparison between the Matrix Pencil Method and the Fourier Transform Technique for High-Resolution Spectral Estimation

... the TFBMPM is less than the one computed using the Standard window as seen in Fig. 19. This is because the Standard window reduces the bias but at the same time increases the variance. On the otherhand, ... 1)Dt0, otherwise.(5.2.3)Figure 16 shows the normalized periodogram for the complex signal of Fig. 1. Note that the SNR as-sumed for this example is ϱ (noiseless samples).In terms of the DTFT the ... otherhand, the use of the Rectangular window makes aFTE biased even for high SNR.In Fig. 21 the behavior of the estimator as the number of samples increases is shown. The inputdata are the same as...
  • 18
  • 415
  • 0
Báo cáo

Báo cáo " A combination of the identification algorithm and the modal superposition method for feedback active control of incomplete measured systems " doc

... measured systems. The aim of this paper is to present a combination of the identification algorithm and the modal superposition method to control the incomplete measured systems. The system ... from the base. In Fig 3, the shapes of the 1st mode, the 3rd mode and the 5th mode are drawn from left to right. As we see, if the sensor locates at the distance L/4, the contribution to the ... characteristics of the beam are taken from [12]. The beam has a square cross-section with the dimension of 21m x 21m. The total mass is 153,000 tons, the total height is 306m, the modulus of elasticity...
  • 8
  • 359
  • 0
Báo cáo

Báo cáo " A combination of the identification algorithm and the modal superposition method for feedback active control of incomplete measured systems" doc

... measured systems. The aim of this paper is to present a combination of the identification algorithm and the modal superposition method to control the incomplete measured systems. The system ... depends on the number and the locations of the sensors. The numerical simulation is applied to a base excited cantilever beam to illustrate the algorithm. The effects of the time delay and the ... large structures. Thus, the aim of this paper is to combine the identification algorithm and the modal superposition method for the linear structures with incomplete measurement, i.e only some...
  • 8
  • 416
  • 0
Fundamentals of the monte carlo method for neutral and charged particle transport

Fundamentals of the monte carlo method for neutral and charged particle transport

... heat-dissipating assemblies, sometimes with coolingfans mounted directly on the assemblies. The other difficulty with small size is the “quantumlimit”. Circuit components can become so small that the ... microscopicand macroscopic physics. Theory can, however, provide intuition for the design of the measurement. Monte Carlo methods are an adjunct to this process as well, serving in the analysis of the experiment ... (8.27)which is the same expression given in Equation 8.25. While the classical picture is useful for visualizing the scattering process it is a little problematic in dealing with cross sections thatcan...
  • 348
  • 424
  • 0

Xem thêm

Từ khóa: an exact method for the capacitated locationrouting problema simplified method for the determination of bulldozing resistanceimmersed boundary method 2dimmersed boundary methodwhen comparing the direct writeoff method and the allowance method of accounting for uncollectibleBáo cáo quy trình mua hàng CT CP Công Nghệ NPVchuyên đề điện xoay chiều theo dạngNghiên cứu sự hình thành lớp bảo vệ và khả năng chống ăn mòn của thép bền thời tiết trong điều kiện khí hậu nhiệt đới việt namNghiên cứu tổ chức pha chế, đánh giá chất lượng thuốc tiêm truyền trong điều kiện dã ngoạiNghiên cứu tổ hợp chất chỉ điểm sinh học vWF, VCAM 1, MCP 1, d dimer trong chẩn đoán và tiên lượng nhồi máu não cấpNghiên cứu vật liệu biến hóa (metamaterials) hấp thụ sóng điện tử ở vùng tần số THzNghiên cứu tổ chức chạy tàu hàng cố định theo thời gian trên đường sắt việt namGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitĐỒ ÁN NGHIÊN CỨU CÔNG NGHỆ KẾT NỐI VÔ TUYẾN CỰ LY XA, CÔNG SUẤT THẤP LPWANPhối hợp giữa phòng văn hóa và thông tin với phòng giáo dục và đào tạo trong việc tuyên truyền, giáo dục, vận động xây dựng nông thôn mới huyện thanh thủy, tỉnh phú thọNghiên cứu, xây dựng phần mềm smartscan và ứng dụng trong bảo vệ mạng máy tính chuyên dùngNghiên cứu về mô hình thống kê học sâu và ứng dụng trong nhận dạng chữ viết tay hạn chếĐịnh tội danh từ thực tiễn huyện Cần Giuộc, tỉnh Long An (Luận văn thạc sĩ)Thiết kế và chế tạo mô hình biến tần (inverter) cho máy điều hòa không khíChuong 2 nhận dạng rui roGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtĐổi mới quản lý tài chính trong hoạt động khoa học xã hội trường hợp viện hàn lâm khoa học xã hội việt namMÔN TRUYỀN THÔNG MARKETING TÍCH HỢPQUẢN LÝ VÀ TÁI CHẾ NHỰA Ở HOA KỲ