... in the metallic parts at the interior of
the engine. The H
2
S is an inorganic acid that attacks the surface of metals when they are
Mass Transfer in Chemical Engineering Processes
1 16 ... and pH on the growth and inactivation of Listeria
monocytogenes. Journal of Food Engineering, Vol .67 , 247–252.
Mass Transfer in Chemical Engineering Processes
132...
... condition using wastewater
as substrate: Influence of substrate loading rate. Current Science 92, 1720-17 26.
Mass Transfer in Chemical Engineering Processes
2 46
C
6
H
12
O
6
+ 6H
2
O 6CO
2
+ ...
Mass Transfer in Chemical Engineering Processes
260
It may informative to note that the parameter , defined as (-f
s
)/()
s
in the formulation,
coinc...
... determined by substituting the values of
I
, obtained from Eq. (75), into Eq. (66 ).
It may be informative to note that for some weakly-burning situations, in which O
2
concentrations in the ... Heterogeneous
Kinetics in the Chemical Reaction/Diffusion Controlled Region. Kinetics of C +
CO
2
→ 2CO at 1200- 160 0°C. Ind. Eng. Chem. Fundam., Vol. 16, No. 2, pp. 235-242,
ISSN 01...
... 34, No. 6, (March 1993), pp. 11 46-
1153, ISSN 0032-3 861
Mass Transfer in Chemical Engineering Processes
16
Das, S.K.; Butler, R.M. Diffusion coefficients of propane and butane in Peace ... unsteady-state mass transfer, since the amount of dye in the fiber is continuously
increasing. Following, Equation 8, was developed by Hill for describing the diffusion of dye...
...
if operating conditions are providing efficiency close to maximal. In general, trays are used
Mass Transfer in Chemical Engineering Processes
42
3. Mass transfer coefficients determination; ... of a mass transfer unit in the Bolles and
Fair (1982) model, is nothing more than the relation between the vapor velocity, based on
Mass Transfer in Chemical Eng...
... and Mass Transfer in a
Honeycomb Structure Rotary Desiccant Dehumidifier”,
Applied Thermal
Engineering
, 2003, (23),pp. 989-1003.
Mass Transfer in Chemical Engineering Processes
66
Lévêque, ... following expression was experimentally obtained (Peasaran & Mills, 1987),
Mass Transfer in Chemical Engineering Processes
86
modeling for the simulation...
... and mass- transfer are used as follows:
0.15Re
ss
Nu
(19)
1.3 0 .67
0.16Re Pr
ss
Nu
(20)
0.15Re
s
Sh
(21)
1.3 0 .67
0.16Re
s
Sh Sc
(22)
Mass Transfer in Chemical Engineering ... binary
Mass Transfer in Chemical Engineering Processes
112
Rafajlovska, 1992; Kense, 1970; Rajaraman et al., 1981). Basically, PCO contains pigments
carotenoi...
... CO
2
/kg amine)
Ca (%v)
DEA
MEA
Mass Transfer in Chemical Engineering Processes
162
optimal value of the electric field intensity E
opt
≈ 400 V/cm, that results in maximal material
disintegration ... absorption in packed columns,
Chemical Engineering
Journal
, No. 1 46, (2009), pp. 362 - 369
Marchaim, U. (1992).
Biogas processes for sustainable development, FA...
...
1
Department of Chemical Engineering, Faculty of Engineering,
King Mongkut’s Institute of Technology Ladkrabang, Bangkok,
2
Department of Chemical Engineering, Faculty of Engineering,
Chulalongkorn ...
higher temperature (thermovinification), or the introduction of extraneous compounds and
Mass Transfer in Chemical Engineering Processes
166
samples, indicating...