0
  1. Trang chủ >
  2. Khoa Học Tự Nhiên >
  3. Hóa học - Dầu khí >

handbook of offshore engineering, vol2

handbook of offshore engineering, vol2

handbook of offshore engineering, vol2

... the vessel to increase with vessel offset in a non-linear manner. HANDBOOK OF OFFSHORE ENGINEERING SUBRATA K. CHAKRABARTI Offshore Structure Analysis, Inc. Plainfield, Illinois, USA Volume ... a static point of view, the cable tension in the vicinity of points A is due to the total weight in sea water of the suspended line length. The progressive effect of line lift-off from the seabed ... the vertical tension applied at the top of the riser. (The ratio is often in the range of 90-99%.) All of these factors are considered in the calculation of the API minimum tension that is used...
  • 652
  • 2,820
  • 1
handbook of offshore engineering volume-1

handbook of offshore engineering volume-1

... “Golden Triangle” of the Gulf of Mexico, offshore West Africa and Brazil (fig. 1.6). As of this writing, HANDBOOK OF OFFSHORE ENGINEERING SUBRATA K. CHAKRABARTI Offshore Structure ... Handbook of Offshore Engineering S. Chakrabarti (Ed.) C 2005 Elsevier Ltd. All rights resened 1 Chapter 1 Historical Development of Offshore Structures Subrata Chakrabarti Offshore ... the birth of the offshore industry is commonly considered as in 1947 when Kerr-McGee completed the first successful offshore well in the Gulf of Mexico in 15 ft (4.6 m) of water off Louisiana...
  • 669
  • 5,614
  • 7
Handbook of Mechanical Engineering Calculations P1

Handbook of Mechanical Engineering Calculations P1

... using 9000 tons of coal per dayis 30,000 tons of CO2, 600 tons of SO2, and 80 tons of NO. A nuclear fission plantusing 14.7 lb (6.67 kg) of uranium produces 6.6 lb (2.99 kg) of highly radioactivematerial. ... ANALYSISShow the effect of turbine engine efficiency on the condition lines of a turbinehaving engine efficiencies of 100 (isentropic expansion), 75, 50, 25, and 0 percent.How much of the available ... (2203.7kJ/kg). The ideal work of the low-pressure section of the turbine is then H4ϪH5ϭ1522.4Ϫ947.4ϭ575.0 Btu /lb (1338 kJ/kg). The actual work output of the low-pressure section of the turbine is...
  • 124
  • 633
  • 1
Handbook of Mechanical Engineering Calculations P2

Handbook of Mechanical Engineering Calculations P2

... (0.28 kg) of water per pound (kg) of dry air. Since the watercontent of the air is a function of the partial pressures, (0.622) (0.5067) /[(2ϫ0.5067)]ϭ0.673 lb of water per lb of dry air ... m2) of condensing surface, a circulating-water flow rate of 10,000gal/ min (630.8 L/s),3⁄4-in (1.9-cm) no. 16 BWG tubes, a water flow rate of 7 ft/s (2.1 m /s), external friction of 20 ft of ... the quantity of steam, lbm/h (kg/h), lost from thecondenser.Calculation Procedure:1. Compute the mass rate of flow per hour of the air leakageThe mass rate of flow per hour of the estimated...
  • 28
  • 692
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P3 pdf

Tài liệu Handbook of Mechanical Engineering Calculations P3 pdf

... combustionand increases the weight of the products of combustion per pound (kilogram) of coal burned. Therefore, the weight of the products of combustion is the sum of theweight of the combustion products ... cu m) of natural gas; 1300 cu ft of air (36.8 cu m) per gal (0.003785 cu m) of No. 2 fuel oil; 1450 cu ft of air (41cu m) per gal of No. 5 fuel oil; 1500 cu ft of air (42.5 cu m) per gal of No. ... the weight of each component by the total weight of the gas. A volume of1 ft3(1 m3) of the gas is used for this computation. Find the weight of eachcomponent and the total weight of 1 ft3(1...
  • 24
  • 744
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P4 pptx

Tài liệu Handbook of Mechanical Engineering Calculations P4 pptx

... Mƒϭlb of moisture per lb fuelburned; Maϭlb of moisture per lb of dry air to furnace; Cbϭlb of carbon burnedper lb of fuel burnedϭCϭRCr; Crϭlb of combustible per lb of refuse; ... lb of fuelϭWc(14,150), where Wcϭlb of unconsumed carbonin refuse per lb of fuel fired. With an ash and refuse of 9.42 percent of the drycoal and combustible in the ash and refuse of 32.3 ... lb of refuse; Rϭlb of refuse per lb of fuel; H2,N2,C,O2,Sϭlb of each element per lb of fuel, asfired; CO2, CO, O2,N2ϭpercentage parts of volumetric analysis of dry combustiongas...
  • 80
  • 634
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P5 pdf

Tài liệu Handbook of Mechanical Engineering Calculations P5 pdf

... conditions of 1800 psia (12,402 kPa) and 1050ЊF(565.6ЊC). At exit from the cylinder the steam has a pressure of 500 psia (3445kPa) and a temperature of 740ЊF (393.3ЊC). A portion of this ... more heaters. Plot the percentimprovement vs. number of stages of extraction, Fig. 6, to observe the effect of additional heaters. A plot of this type shows the decreasing gains made by addi-tional ... power system, net output of the existing system isincreased, as noted, because of increasing flow to the steam turbine’s condenser.This increased output offsets the cost of interconnection to the...
  • 16
  • 616
  • 1
Tài liệu Handbook of Mechanical Engineering Calculations P6 pdf

Tài liệu Handbook of Mechanical Engineering Calculations P6 pdf

... average heat of vaporization of 1000 Btu / lb (2330 kJ / kg) of steam,this exhaust gas flow could generate 8,880,000 /1000ϭ8880 lb/h (4032 kg/h) of steam. If oil with a heating value of 145,000 ... types of fuels and the internal-combustion engines usingthem. Note that where the cost of the fuel is high, the cost of the engine is low;where the cost of the fuel is low, the cost of the ... horsepowerrequirements of the driven load.On equipment of entirely new design, it is often difficult to ascertain the amount of power necessary. In such instances, a rough estimate of the horsepower...
  • 44
  • 734
  • 0
Tài liệu Handbook of Mechanical Engineering Calculations P7 docx

Tài liệu Handbook of Mechanical Engineering Calculations P7 docx

... is 80 percent of bep capacity. For a specific speed of 1090, asbefore, the percentages of bep head and efficiency are shown in Figs. 36 and 37:79.5 percent of bep head and percent of bep efficiency. ... speed is 80 percent of bep speed at2880 r/min. For a specific speed of 1090, the percentages of bep capacity, effi-ciency, and power are 107 percent of the capacity, 94 percent of the efficiency, ... riseIn any centrifugal pump, the rate of temperature rise trЊF/minϭ42.4(bhp inputat shutoff)/wc, where wϭweight of liquid in the pump, lb; cϭspecific heat of the liquid in the pump, Btu /...
  • 86
  • 916
  • 14
Tài liệu Handbook of Mechanical Engineering Calculations P8 doc

Tài liệu Handbook of Mechanical Engineering Calculations P8 doc

... cost of each type of pipeuses the capital-recovery equation, Aϭ(PϪL)(CR)ϩLi1ϩc, where Aϭannualcost, $; Pϭinitial cost of each type of piping, $; Lϭsalvage value of each type of ... Determine the cost of the leaking steamThe cost of a steam leak, C $ϭLSH /1000, where Cϭannual cost of steam leak,$, for H hours of yearly operation of the pipe; Sϭcost of steam, $ per 1000 ... quantity of heat entering the desuperheater via the spray interms of the amount of waterThe quantity of heat entering the desuperheater via the spray, Qϭwϫwhereh ,ƒthe amount of water...
  • 136
  • 560
  • 0

Xem thêm

Từ khóa: handbook of food engineeringthe standard handbook of engineering calculationsstandard handbook of engineering calculations hicksstandard handbook of engineering calculations 3rd editionstandard handbook of engineering calculations bookstandard handbook of engineering calculations 1972Báo cáo thực tập tại nhà thuốc tại Thành phố Hồ Chí Minh năm 2018Nghiên cứu sự biến đổi một số cytokin ở bệnh nhân xơ cứng bì hệ thốngNghiên cứu tổ hợp chất chỉ điểm sinh học vWF, VCAM 1, MCP 1, d dimer trong chẩn đoán và tiên lượng nhồi máu não cấpMột số giải pháp nâng cao chất lượng streaming thích ứng video trên nền giao thức HTTPNghiên cứu tổ chức chạy tàu hàng cố định theo thời gian trên đường sắt việt namGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitĐỒ ÁN NGHIÊN CỨU CÔNG NGHỆ KẾT NỐI VÔ TUYẾN CỰ LY XA, CÔNG SUẤT THẤP LPWANĐỒ ÁN NGHIÊN CỨU CÔNG NGHỆ KẾT NỐI VÔ TUYẾN CỰ LY XA, CÔNG SUẤT THẤP LPWANPhối hợp giữa phòng văn hóa và thông tin với phòng giáo dục và đào tạo trong việc tuyên truyền, giáo dục, vận động xây dựng nông thôn mới huyện thanh thủy, tỉnh phú thọNghiên cứu, xây dựng phần mềm smartscan và ứng dụng trong bảo vệ mạng máy tính chuyên dùngNghiên cứu về mô hình thống kê học sâu và ứng dụng trong nhận dạng chữ viết tay hạn chếTìm hiểu công cụ đánh giá hệ thống đảm bảo an toàn hệ thống thông tinSở hữu ruộng đất và kinh tế nông nghiệp châu ôn (lạng sơn) nửa đầu thế kỷ XIXKiểm sát việc giải quyết tố giác, tin báo về tội phạm và kiến nghị khởi tố theo pháp luật tố tụng hình sự Việt Nam từ thực tiễn tỉnh Bình Định (Luận văn thạc sĩ)Quản lý nợ xấu tại Agribank chi nhánh huyện Phù Yên, tỉnh Sơn La (Luận văn thạc sĩ)Tăng trưởng tín dụng hộ sản xuất nông nghiệp tại Ngân hàng Nông nghiệp và Phát triển nông thôn Việt Nam chi nhánh tỉnh Bắc Giang (Luận văn thạc sĩ)Tranh tụng tại phiên tòa hình sự sơ thẩm theo pháp luật tố tụng hình sự Việt Nam từ thực tiễn xét xử của các Tòa án quân sự Quân khu (Luận văn thạc sĩ)Trách nhiệm của người sử dụng lao động đối với lao động nữ theo pháp luật lao động Việt Nam từ thực tiễn các khu công nghiệp tại thành phố Hồ Chí Minh (Luận văn thạc sĩ)BÀI HOÀN CHỈNH TỔNG QUAN VỀ MẠNG XÃ HỘI